The car is only going to be used for DEs, so it won't see any street use.
This is the reason I wanted some advice on this, because we need to do this right. I realize that poor design might be worse than your stock setup.
6 point sounds like the way to go then I guess
Where we bolt it in must be carefully looked at. It's one of our obstacles. It seems like our seat bracket has bolt holes for the lap belts, our shoulder belts will go onto the bar (which I discovered has a complete horizontal when I took another look at it), and we'll have to figure out a safe place for the submarine belts to bolt on.
Who would be a professional in this case that could advice and inspect a design like this? Any in the area, like RRT maybe?
I've looked and heard a lot about HANS and I will be sure to include it in my safety budget.
Another question, what is the standard for belts? What should we consider when choosing a harness? Safety is a great concern, but we are also on a budget to a certain extent.
Bookmarks