Has anyone had front brake pads break on them? I had a set of Hawk HT-10 race pads, about 1/2 life, on stock e36 front brakes, and the pad material cracked top-bottom where the piston pushes on the...

Anyone converting their 328 to a track car or upgrading their rear deck speakers? I'm looking for the stock round speaker boxes from the rear deck. Please contact me offline -...

Has anyone tried removing/disabling the ASC throttle body from their e36? I like the ability of the ASC system to brake a spinning wheel, but hate when the throttle control kicks in and puts the car...

Was your SRS light on? Or was it covered up?

Thanks,
Keith

This reply is way out of date, but in case it helps someone out.... Since your car isn't all-wheel drive, you don't need to turn off the DSC if you've got equal diameter tires on the rear. DSC...

Does Martin MOtorsports do good work installing aftermarket BMW parts (ex. lightened flywheel/clutch), as well?

Related to the VA inspection question, has anyone replaced their stock airbag wheel with an aftermarket non-airbag steering wheel, and passed VA inspection?

Sonti
'95 325i

My '95 325i with 103K is consistently knocking. I can hear it primarily under light throttle, but it intermittently shows up under full throttle as well. I've tried several brands of gasoline as...

In my experience, brake caliper grease will change in consistency after a hard track event. This does make the pins harder to get out the next time, but not impossible. I also found that the rubber...

Excellent! Just what I was looking for. Thanks!

Sorry, I should have mentioned that I have installed a UUC short shifter with the SS carrier bearings, Delrin bushings, and new "bitch clip". The play is still there. It just seems strange that, as...

Does anyone know if a Z3 or Z4 steering wheel will fit an e36 325? I'd like to replace the stock boat-sized wheel with something smaller, but retain the airbag. I haven't found any aftermarket...

I've got a '95 325i 5-speed (102K) which has an 1" of play left-right in the shifter in each gear. I tracked the problem down to the rod that is attached to the shifter rod, and that goes into the...