I am in Annapolis and Redd's is an independent that I have used in the past. It's a little far from Pax but they are reputable.

typically the dealers give CCA Members 10-20% discount. You can pre-order from the sponsor after you get your confirmation.

Stick with the getBMWparts oil kit.

We ask that you buy parts from the sponsor if at all possible. If you have parts, tell the coordinator before the event so s/he can get it cleared

On the calendar of events you will find several DIY events. We usually run one a month.

Welcome to the d club. I will be at the BGP in the Corral all weekend as well.

Looks good. Are we on the hunt for a new place?

no

You can call Redd's in Downtown Annapolis. They are a BIMRS shop.

I'm willing to hang out, check out the shop, and help

Paul - are we going to have any meetings in MD? Its difficult for some of us to get to Arlington. Can it be rotated?

I had an expansion tank failure on the 1999 328i at about 110k. It is a poorly made plastic part. If you are going to keep the car, expect to replace it every 50k for safety reasons.

Go ahead and flush the transmission. There are several DIYs on the net on how to do it. I used MaxLife (it is BMW compatible). Figure parts and fluid will cost you around $100. It can be done at...

Would you have any advice if you didn't go the BSW route? Anything that is easy or a DIY?

AtSpeed in Columbia is the largest Dinan dealer on the east coast. Call Bob Miller. He can advise you.

This is great. I want to pass him in my 328?

I found the one in Madison and I just mapped it from Frederick. It's 103 miles point to point, not counting getting to Frederick in the morning and getting home from Madison after dinner.

For...

Thanks Paul - I will call him.

I looked up the Bararian Chef and its in Fredericksburg VA. For some reason I was thinking the Bavarian Inn which in WV west of Thurmont.

So it looks like we are starting in Frederick MD and...

I am wondering if there is a good shop / person who installs the clear bras on cars. I talked to Tischer and they want $1300.

Any suggestions?

You also have the option of signing up for a DIY session and doing it at a shop with our chapter.

Registration opened on 7/4/2010. MSR is accepting requests.

I replaced my front control arms and bushings last year at a DIY, but I ran over on timing. The problem I had was reattaching the control arms to the suspension because of the lack of room for the...

I have Axxis ULT on my 325 and they are fine for daily driving. I like Hawk products alot. I ran the HPS before the Axxis and liked the HPS better. I wouldn't recommend the HP+, they are too...

I would be interested, but would need some advance notification with work and all. And if there are not enough people for the $65 rate, I would be willing to pay more...